|
TGB-2515 Thermal Gradient Bar
Gradient Area: 250 X 150 mm
Material: ALuminum, clear anodized
Embeded Sensor: 3 Wire RTD, 100 ohm
|
TECA’s Gradient Bar options expand the use of the CPV line of Cold Plates. With a TECA model CPV cold plate at each end the gradient bar has programmable gradient areas with near linear gradients between the two ends and near uniform temperatures along the width of the bar. The temperature at each end of the gradient area can be programmed to a single set point or with a ramp/step and soak profile creating constant, expanding, contracting or moving gradients. Set the gradient profile to be large for initial observations then adjust the end set points to zoom in on a temperature range of interest. The temperature at the end of the gradient area is measured from underneath the plate at approximately .05 from the surface leaving the top gradient area clean and smooth. Optional external surface sensors can be used to change the size of the gradient area. |
Click on the image for larger view
Picture shows TGB-2515 Thermal Gradient Bar used with two AHP-301CPV
Click on the image for a larger view of the performance curve
CLick on the image for larger view
Click on the image to open the PDF file